What is Craig?

*Craig is a bot that records audio in voice channels and makes them available for download afterwards.*

<aside> 💡 There are two Craig bots. :craig: and :giarc:

Giarc is a second instance of Craig, meant to be a backup. It will record in the same channel, but you are supposed to be able to use Giarc independently of Craig.

To do so, use @Giarc as the command prefix instead of :craig:

</aside>

How to Record

• Join the voice channel you would like to record
• While in that voice channel, you should be able to summon Craig in any text channel you're working in.
• As an L2 Member, type in (atCraig or atGiarc) **@![RECORDING] ERROR CANNOT SEND M**, join This will invite the Craig bot into the voice channel you are in and will immediately begin recording.

<aside> 💡 If Craig isn't working there, try going to the #bot-commands channel [Under General (Level 1), above Watercooler] to use the commands.

</aside>

• When you begin recording, the Craig bot will direct message you with links to access your audio recording.
• When you are done recording, summon Craig again, and add , leave

You can also explicitly specify a channel name. For instance, to record the “General” channel, type @![RECORDING] ERROR CANNOT SEND M, join General

Tips

• Don't start Craig until the event is about to start. If there is silence, Craig will stop recording after 5 minutes.
• If everyone leaves the voice channel while Craig is still recording, he will stop recording. You don't need to use the leave command in that case.

Tips on using Giarc (the backup of Craig)